2555 Electroplated wear-resistant zinc alloy exposed drawer door handle

Product description

The 2555 Electroplated Wear-Resistant Zinc Alloy Exposed Drawer Door Handles offer a comfortable grip and effortless operation. Zinc alloy, renowned for its high strength, good toughness, and corrosion resistance, ensures that the door handles remain durable and perform well under various environmental conditions. Through the electroplating process, a protective film is applied to the surface of the zinc alloy, enhancing its wear and oxidation resistance.

These surface-mounted drawer door handles, made from electroplated wear-resistant zinc alloy, can withstand frequent use without deformation or damage. They boast high load-bearing capacity, meeting the load-bearing requirements of drawers and doors effectively. Moreover, such door handles typically offer sealing performance, preventing the infiltration of dust and moisture and thereby safeguarding the items stored inside the drawer from damage.

Exposed handle installation location:
1. Handles are generally divided into horizontal installation and vertical installation. Regardless of whether they are installed horizontally or vertically, they must be unified.
2. The shape and direction of the handle should be consistent.
3. Drawer panels, upper flip-up doors, and lower flip-up door handles must be installed horizontally.
4. The upper cabinet door panel handle is installed below the door panel, and the lower cabinet door panel handle is installed above the door panel.
5. The installation position of the handle of the tall (long) cabinet door panel is determined through negotiation based on the height of the owner. Do not blindly decide on your own.
6. The handles of drawer panels, bottom flip doors, top flip doors, and door panels with door accessories are generally installed in the width center of the door panels. The handles of door panels that open doors are generally installed on the side away from the installation hinges.
7. There are two installation heights for the handles of the drawer panel. They can be installed at the height center of the panel or at the same height from the upper edge of the panel.
8. When installing the handle, the distance between the edge hole of the handle and the edge of the board is generally 45mm.
9. When installing handles on door panels with shapes on the surface (such as solid wood door panels), be sure to confirm with the owner, because sometimes the handles selected by the designer may not be suitable for installation, and the installation effect will be very unsightly.